Mobile exhaust gas purification tower

Category：

Waste Gas Treatment Equipment

Category：

Key Equipment

Category：

Products

The mobile exhaust gas purification tower is a countercurrent atomization spray tower, filled with special packing. Compared with conventional packing, this packing has advantages such as large specific surface area, high porosity, low resistance, and good wetting performance.

Keywords：

Mobile exhaust gas purification tower

Tel：

HOTLINE：400-678-1829

ZHANG GONG：+86-18865361829

CONSULT

OTHER PRODUCTS

詳細介紹

圖文詳情

(1) Equipment Introduction
The mobile exhaust gas purification tower is a countercurrent atomization spray tower, filled with special packing. Compared with conventional packing, this packing has advantages such as large specific surface area, high porosity, low resistance, and good wetting performance. It can provide a sufficient interface for gas-liquid mass transfer process and improve mass transfer efficiency. The spray system inside the tower is composed of a specially designed non clogging spiral nozzle with a reasonable layout, which has good atomization effect and evenly disperses the liquid phase to form a flowing liquid film. Mainly for washing and pre-treatment of exhaust gas, reducing the acidic and soluble components in the exhaust gas, and reducing the load of back-end processing equipment. Prevent large particle pollutants and impurities from blocking the subsequent processing unit. The dust and water soluble pollution factors carried in the exhaust gas are removed to achieve preliminary purification. The purified exhaust gas is discharged from the top of the tower, and the liquid phase that absorbs pollutants is collected at the bottom of the tower. It is recycled by a spray pump and replaced and discharged after reaching a certain concentration.
This equipment is made of PP or fiberglass material with good corrosion resistance, and all electrical components are explosion-proof motors, which will not cause dangerous accidents due to high VOCs concentration. The size of the spray tower is designed based on the air volume, and the purification tower base can be equipped with universal wheels for easy movement.

(2) Equipment model

Purification Tower Model Table
Purification tower model	processing capacity-m³/h	tower diameter-mm	Tower height-mm	Exhaust gas inlet-mm	Exhaust gas outlet-mm
HK-V300	300	Ø350	1300	Ø110	Ø110
HK-V600	600	Ø520	1500	Ø160	Ø160
HK-V1200	1200	Ø630	1600	Ø200	Ø200
HK-V1800	1800	Ø750	1750	Ø250	Ø250